Users Forum

ADONIS Category => ADONIS Users => Topic started by: Profray on April 04, 2024, 10:53:36 am

Title: Releasing tieback tension
Post by: Profray on April 04, 2024, 10:53:36 am

Is there a way to cut/release or "untension" a pre-tensioned tieback? I wanted to see the impact of loss of tieback support on excavation.

Title: Re: Releasing tieback tension
Post by: Roozbeh on April 04, 2024, 11:20:24 am

Hi,

you can simply delete the segment (or the whole tieback) and rerun the model.

-Roozbeh

Title: Re: Releasing tieback tension
Post by: Profray on April 08, 2024, 10:25:04 am

Thanks for the answer. I was looking for a scenario where the excavation progresses such as:
1. Excavate 1st level, install and tension 1st tieback
2. Same with 2nd level
3. Same with 3rd level
4. Final excavation to bottom
5. Lose tension in 2nd level tieback.

So, I do not think that would be the same as running the sequence and skipping 2nd tieback as you go down.