Users Forum

HYRCAN Category => HYRCAN Users => Topic started by: giofed on December 09, 2024, 10:35:00 am

Title: Color scale
Post by: giofed on December 09, 2024, 10:35:00 am

Hello,

I have made a model where a piled foundation is modeled in a slope.
I can send you the model but it is larger than the allowed by the forum.
I get the global FOS and all the curves that the program calculates.
However I expected to see a different color for each sliding surface, while I see all red.

For example, some surface pass through the foundation with a high shear strength, so I would expect a color different from red.
Also, the numbers in the color scale look strange. It is probably some format problem.

Best

Giorgio

Title: Re: Color scale
Post by: Roozbeh on December 09, 2024, 02:17:17 pm

Hi, please attach the script (*.hjs) file instead of the binary file. The script file is a small text file that?s easy to share. Use 'Save As Script' to save it as a new text file, then open the file and clean up the commands to match the format shown in the tutorials. This will make it much easier for me to follow the model and process.

Title: Re: Color scale
Post by: giofed on December 14, 2024, 05:35:54 am

Good morning,

Thank you. Here attached the exported file.

Best
Giorgio

Title: Re: Color scale
Post by: Roozbeh on December 19, 2024, 10:00:16 am

Thanks, I received your script. The surface filtering module needs some revisions. Once it's ready, I?ll release the new version.

Title: Re: Color scale
Post by: giofed on December 20, 2024, 04:41:13 am

Thank you very much! Looking forward to the new version of the software.
Giorgio