Users Forum

HYRCAN Category => Bugs and Problems => Topic started by: Giovanni S. on March 03, 2026, 11:34:15 am

Title: Bug with slices visualization out of the sliding limits (and calculation?)
Post by: Giovanni S. on March 03, 2026, 11:34:15 am

Hello,

I am contacting you for a bug I have encountered by performing a (trial) slope stability analysis.
The identified minimum sliding surface is very surficial.
By clicking on "Show Slices", HYRCAN shows slices outsdide the limits defined for sliding surfaces (??).
Please, have a look to attached image.

It does not seem just a graphical issue because forces are computed for slices out of the limits.
Could you please provide some support?

Thank you.

Giovanni

Title: Re: Bug with slices visualization out of the sliding limits (and calculation?)
Post by: Roozbeh on March 04, 2026, 09:46:28 am

Hi Giovanni,

Could you please upload the script associated with this model so I can reproduce the issue on my end?

-Roozbeh

Title: Re: Bug with slices visualization out of the sliding limits (and calculation?)
Post by: Giovanni S. on March 05, 2026, 12:22:28 am

Hello Roozbeh,

yes, of course.
Please, find attached the script.

Thank you.

Giovanni

Title: Re: Bug with slices visualization out of the sliding limits (and calculation?)
Post by: Giovanni S. on March 17, 2026, 07:59:29 am

Hello Roozbeh,

have you got any possibility to analyze what I have sent you?

Thank you.

Giovanni

Title: Re: Bug with slices visualization out of the sliding limits (and calculation?)
Post by: Roozbeh on March 17, 2026, 08:02:37 am

Hi, I believe I?ve identified the source of the issue. I?ll upload a new release in a couple of days.

Title: Re: Bug with slices visualization out of the sliding limits (and calculation?)
Post by: Giovanni S. on March 23, 2026, 01:05:52 am

Thank you very much.