Hi all,

I have attached an example of using the scripting to generate a simple slope.

A user can provide a slope height and angle and the model can automatically figure out the geometry.

A user can provide a load and load offset and the script will automatically apply the load at the crest of the slope.

A user can also set up materials, although this probably a little less general and something that might need to not be scripted.

Note: There currently appears to be a bug when running this script in the load not showing on the results page. The FOS appears to have considered the load correctly however. This issue is to be raised in a separate thread on the appropriate board.

Hi Jesse, I couldn`t download your script because of "404 - Attachment Not Found", can you send it to me? Is it possible to create models in Hyrcan using command lines? Do you have any template?

Att.

Claudio.

Hi,

you can use this file instead.