Hyrcan 2.0.2 crashes on Seismic Load in Windows 10

I am using Hyrcan 2.0.2 and adding a Seismic Load. Then I am running "compute" of my model in Windows 10, and finally I get the results.

So far, so good!

However, when I am reloading my model and making some modifications, for example by adding a Load, and then I am trying to run "compute" again, the program crashes and closes down.

When I am reloading once again my model without making any modifications at all, and then I am trying to run "compute", the program again crashes and closes down.

I have installed this version of Hyrcan, i.e. 2.0.2, to another three workstations and to one HP Laptop, and exactly the same problem happened again.

I should let you know, that by using a previous version, i.e. HYRCAN_1.90.2_Win_x86_Languages, there is not at all any sort of problems...

This problem happens on version Hyrcan 2.0.2 only, and ONLY if I add a Seismic Load... Without Seismic Load, there is not any bug at all...

Is there any fixing for this problem?

Thank you.

Hi, thanks for the comment. I figured out the problem. Perhaps in couple of hours I will be able to submit a new revision.