Hello,

I am contacting you for a bug I have encountered by performing a (trial) slope stability analysis.
The identified minimum sliding surface is very surficial.
By clicking on "Show Slices", HYRCAN shows slices outsdide the limits defined for sliding surfaces (??).
Please, have a look to attached image.

It does not seem just a graphical issue because forces are computed for slices out of the limits.
Could you please provide some support?

Thank you.

Giovanni

Hi Giovanni,

Could you please upload the script associated with this model so I can reproduce the issue on my end?

-Roozbeh

Hello Roozbeh,

yes, of course.
Please, find attached the script.

Thank you.

Giovanni

Hello Roozbeh,

have you got any possibility to analyze what I have sent you?

Thank you.

Giovanni

Hi, I believe I?ve identified the source of the issue. I?ll upload a new release in a couple of days.